chriswitor.com
chriswitor.com
chriswitor.com
Triumph 2000, 2500, 2.5 Specialist Parts Supplier. Six cylinder Triumph engine parts available.

Details

211061A-CL

Price (Ex VAT): £20.00

 Clutch Slave Cylinder

Product ID 211061A-CL
Date Added
17th December 2010

 Clutch Slave Cylinder 211061A 7/8" Bore (longer travel than 1") Best use with all aftermarket Clutches 2000 & 2.5

NB Bracket136353 requires slotting to accept current slave profile, or use our ready modified bracket 136353A

Clutch hydraulics are notoriously difficult to bleed on the 2000 range.

Ensure the internal spring in the master cylinder which is prone to break isn’t broken and replace if necessary.

Ensure the slave is fitted to the rear of its bracket.

Ensure the bleed nipple is uppermost on the slave with the pipe lowermost.

BLEEDING -

With the slave fitted, push and hold the pedal down, open the bleed nipple on the slave, and push the push rod back into the slave via the cross shaft on the gearbox.

Then close the bleed nipple and lift the pedal.

Leave for up to a minute, allowing the spring within the slave to slowly push the piston and push rod back which draws fluid down from the master cylinder.

Repeat until fluid exits the bleed nipple. Then with the bleed nipple closed pump the pedal, resistance should build. If not repeat the previous sequence.

Once a firm pedal is achieved, open the  bleed nipple one more time with the pedal down, close and re check fluid level.

Product Reviews
No Reviews For This Product.